ARCELI Mega 2560 Pro Mini Built-in, MCU ATmega2560, USB CH340G Electronics

Product Information

The Mega 2560 Pro Mini ATMEGA2560-16AU USB CH340G Development Board is based on the ATmega2560 microcontroller. Mega PRO (Embed) 2560 CH340G / ATmega2560-connects to the computer through the microUSB cable (used for Android smartphones (almost all)).

Ideal for powering most initial projects, but note that higher input voltages result in lower outgoing current. Before you make your purchase, it’s helpful to know the measurements of the area you plan to place the furniture. v=1588659542","options":["Title"],"media":[{"alt":"Mini Mega 2560 Pro Micro Usb Ch340G Atmega2560-16Au For Arduino Mega R3 Motherboard","id":6678961782855,"position":1,"preview_image":{"aspect_ratio":1.In future, shields will be compatible both with the board that use the AVR, which operate with 5V and with the board that uses ATSAM3X8E, that operate with 3. However, the final responsibility for your actions is entirely your responsibility and The Micro Hut and its employees can not be held responsible. The board can be powered directly through the Micro USB connector, or via the corresponding contact on the board (Vin). The ATmega16U2 (or 8U2 in the rev1 and rev2 boards) firmware source code is available in the Arduino repository. v=1588659542","width":1000},{"alt":"Mini Mega 2560 Pro Micro Usb Ch340G Atmega2560-16Au For Arduino Mega R3 Motherboard","id":6678962012231,"position":5,"preview_image":{"aspect_ratio":1.

The board has a micro USB connector to allow you to connect the microcontroller to the computer and to use the Arduino IDE. When working on the frequency of 12 MHz, a stable result of data exchange is obtained (it is necessary to install the drivers on the computer). Stable USB-UART Interface: Features the CH340G chip, operating at 12 MHz for a consistent and stable data exchange.This bypasses the on-board regulators and and should only be used if a stable 5V power source is available. The board has a Micro USB connector that allows you to connect the micro-controller to the computer via the USB-UART adapter CH340 (A driver installation may be required). Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). You should also measure any doorways and hallways through which the furniture will pass to get to its final destination.

The Mega 2560 Pro with CH340 is compatible with the Arduino Mega 2560 but with a significantly reduced physical footprint for embedded applications. Whilst considerable efforts are made to ensure that the information is of the highest quality, no warranties or representations are made, nor are to be implied, as to the accuracy, merchantability or fitness for purpose of the information provided. There are ways around this but it involves additional electronics and as I don't really use SPI much, I've decided to not bother. It uses the original ATmega2560-16AU chip, a 16 MHz high-quality quartz resonator, and the CH340G USB-UART interface.

The voltage regulator allows to use up to 12 volt as an input value, however we do not recommend exceeding the recommended values aforementioned, since this can lead to excessive heat and damage the device.