Salmue Cotton Bed Canopy+Steel Ring+Hooks +Hook Base Plates +Adhesive Tapes+Screws Block Out Light Dome Princess Mosquito Net Equip With Assembly Tools(Khaki)

Product Information

Toilet frames are designed to provide horizontal support for pushing up from a toilet, or for steadying the body when lowering onto a toilet. The frame, which stands over the top of the toilet, can either be free standing or fixed to the floor. It is recommended that it is run continuously from the bottom to the top of your flight of stairs, including going around the edge of any intervening landings and across window openings. The handrail should be allowed to continue past the top and bottom steps by 300mm. The rail should be mounted at a height that the user can comfortably reach whilst stood both from outside the bath and from in the bath. Ensure that the wall is strong enough to take the weight of this type of rail. Care should be taken that the user never bends down underneath the rail (e.g. to reach their feet) when sat in the bath as they could trap their head under the rail.

Newel rails are designed to turn through 90o around the newel post (the upright post of the stair banister). They provide a continuous grip as the user reaches the bottom or top of the stairs and turns the corner. They are available in a range of sizes. A polished or chrome finish is attractive and hard wearing but can be quite slippery to hold, especially when hands are wet. A wide range of finished hand rails are available from DIY chains for you to choose from. A plain 50mm mop head cross section softwood rail may be used. Using one rail: The rail is fitted starting at a point approximately 25mm forward of your knee and approximately 50-70mm above your elbow (when seated on the toilet with your arms down against your side), at an angle running at 45 degrees forwards and upwards away from you. This may help you to support the weight of your arm whilst pulling with your hand higher up the rail. See above diagram.Some have a support leg which rests down on the floor when the rail is horizontal. Some models provide a single horizontal rail which provides support at one height; others consist of a looped rail which provides two alternative gripping positions. Some of these rails have a built-in toilet roll holder. As a general guide there are two options for wall mounted rails by the toilet. If you have the same strength on both sides of your body it may be a good idea to have supports fixed on both sides of the toilet so that you can use both arms.

Part of the rail can be fixed at an angle of 13° upwards towards the head end of the bath to provide an inclined support. Vertical rails may assist when pulling up into a standing position or for just maintaining balance. The following is general guidance. When an individual user is known, personal factors such as the height of the person should be given priority. An epoxy, paint or plastic finish provides a warmer feel to rails, is hard wearing and will reduce the effects of condensation. A choice of colour allows for a colour contrast with the wall for users with low vision or for co-ordination of bathroom accessories.The finish of the rails may be important from an aesthetic point of view and also for the grip surface it provides. Staircases usually have a handrail on one side, although this may not extend to the full length of the staircase. Most DIY stores sell handrails which can be used to extend the existing handrail all the way up the staircase if it is required. Adding a handrail to the other side of the staircase will provide more support where needed. Long lengths of rail are available and may also be installed along corridors. sitting down or standing up from the toilet, or standing to manage your clothes when using a toilet Some hinged wall-mounted rails can be supplied with a support leg which rests down on the floor when the rail is horizontal, transferring some of the load from the wall to the floor.

Alternatively, if there are no obstructions outside the bath (e.g. the sink or toilet) a vertical grab rail could be installed on the wall at the tap end of the bath. This is useful when stepping in and out of the bath and also to hold onto if standing to shower. When standing from a sitting position in the bath you may find it helpful to hold one horizontal wall-fixed grab rail (placed above the bath) with one hand and use the outer rim of the bath with the other hand to push against. There needs to be a 50-60mm clearance between the wall and all handrails.Consider your daily routine. What movements are you making or what activities are you doing when you feel that additional support, or something to hold on to, would give you extra safety? For example: They are fixed to the wall or to the floor behind the toilet and can fold down to a horizontal position alongside the toilet. THIS BED LEVER FITS ALL TYPES OF SLATTED DIVAN ADJUSTABLE BEDS FROM ALL COMPANIES AND 95% OF ALL OTHER LAYBROOK ADJUSTABLE BEDS, ALL LAYBROOK WOODEN ADJUSTABLE BED (NEEDS A DIFFERENT BOTTOM PLATE), ALL LAYBROOK LEATHER ADJUSTABLE BEDS. Fixing to UPVC plastic door frames should be avoided as the frames are unlikely to have the necessary internal materials in the required area to support a grab rail's fixings.