Ronseal Smooth Finish Fller Big Hole 1.2L

Product Information

Powder filler is the most practical choice if you have a lot of surfaces to prepare. It’s cheaper than ready-mixed paste and you’ll get a lot of filler out of one bag. The main downside is that you need to prepare it before use by mixing the powder with water. Another issue is that once you’ve finished with the prepared filler, you can’t reuse anything that’s left over as it will just dry out. Now you will need a piece of plasterboard to fill the hole. Ideally this needs to be thinner than the current plasterboard. Measure and cut to fill the hole. Fix in place against the noggins with plasterboard screws or nails.

If you’re filling smaller spaces or just don’t want the potential mess of powder, ready-mixed paste is the best solution. It’s practical and can be reused – just make sure you seal it tightly after use. However, paste is more expensive than powder and will already be pre-mixed in precise ratios to a particular consistency.

Once the patch is dry and firmly in position, gently remove the screw. Use patching plaster, all purpose filler or multi-finish plaster — mix up enough to cover the patch and gently press into the hole and spread with a putty knife that is larger than the hole to help get a smooth finish.

Now draw two lines across the gap to create a rectangle around the hole. Cut out the existing plasterboard with a sharp Stanley knife or use a small jab saw.

If you’re confused over which filler is right for your job why not take a look at our video to help you. A high-quality wood primer needs to be applied so that the paint would adhere to the surface of the wood you’re painting. For deeper repairs, above 50mm, build the filler up in layers ensuring it has dried between applications.